HomeMade (2007)

1 large lampshade, 1 smaller lampshade, 1 length of cable, 1 light fitting (with switch), 1 plug & 1 energy-saver light bulb.

INSTRUCTIONS:
1. Make a hole in the 'base' lampshade with a hole punch and feed the cable through. This will want to be somewhere along the bottom of your light.
2. Wire the cable to the light fitting and use the fitting to connect the two shades together. It's best to buy a fitting with a switch in it, but not essential.
3. Connect an ENERGY SAVER light bulb and wire the plug.
4. Switch on.

Similar products to be shown soon.

Disclaimer: Electricity is dangerous and can be hazardous. If in doubt call a qualified electrician. Always take care when dealing with electrical equipment, make sure all connections are properly fitted and insulated before connecting to the mains supply. Jeremy Brown does not accept any responsibility for loss or damages to any persons or any person's property. Construct at your own risk.

CLIENT // Personal project
MANUFACTURED // N/A
AVAILABILITY // N/A
TECHNICAL INFO // N/A